Assembly instructions

• Attach the housing to the panel.  Slip snap ring over the cable.

• Strip the cable jacket 20 mm (3/4").  Strip the wire ends max. 4 mm (5/32").  Solder or crimp the contacts

Male inserts:

• Push the insert into the housing.  Pay attention to the desired coding (coding groove, coding key).

• Press the snap ring together slightly and push it into the housing until it snaps in position.

• Verify proper assembly by pushing on the insert.

Female inserts:

• Push the snap ring onto the insert.

• Press the snap ring together slightly and push it into the housing until it snaps in position.  Pay attention to the desired coding (coding groove, coding key)

• Verify proper assembly by pushing on the insert.