| Multi-Hole: Liquid
Tight Cord Grip Fittings -
Metric Threads
- Nylon, Nickel Plated Brass |
|
IMPORTANT:
Design Parameters: Cable diameter should not be
less than 80% of hole diameter and the difference
between hole and cable diameter should never
exceed .04" (1 mm).The Multi Cable fittings will
meet NEMA 4x = IP65 if the design parameters are
complied with.
To verify a submersible NEMA 6= IP68 application,
the final assembly of cables and fittings must be
tested by the customer or submitted at the
customer's expense to an independent test lab or
for certification.
|
|
How to Order
Non-Listed Parts |
|
Note 1: To Substitute a different thread
type replace the 5th position with the following:
"A" PG Thread,"N"
NPT Thread, "M"
Metric Thread. e.g. CD09N1-BK becomes CD09A1-BK.
Note 2: Not available
in Nickel Plated Brass with NPT Threads.
- Strain Relief Fitting
with Flex Nut
Substitute "F" for "D"
e.g. CDO9N1-BK becomes CF09N1-BK.
- Snap Elbow Fitting
with Dome Nut
Substitute "E" for "C"
e.g. CD09N1-BK becomes ED09N1-BK.
- Snap Elbow with Flex
Nut
Substitute "EF" for "CD"
e.g. CD09N1-BK becomes EF09N1-BK.
- Nickel Plated Brass
Strain Relief Fitting
Substitute "BR" for "BK"
e.g. CD09N1-BK becomes CD09N1-BR.
- Gray Strain Relief
Fitting
Substitute "GY" for "BK"
e.g. CD13N2-BK becomes CD13N2-GY.
|
|
SPECIAL INTEREST:
For a minimum order of 1,000 pieces any special
insert hole configuration is available at no extra
cost. For small quantities, we suggest drilling
the frozen solid plug insert, using the fitting as
a fixture. |
|
|
|
|
